Search this Blog

Monday, October 17, 2011

VTP question about "Show Run" in Cisco 2950

We have a Cisco 2950. When we type "show vtp status" and it tells me this switch is in client mode, and it's in such-and-such domain, etc., However, the command does not show this information when we type "show run"? Can some one please explain?

Because the vlan configuration when running in VTP server/client mode is stored in the vlan.dat file and not in the running config. If you put the switch in VTP transparent mode then the vlan information is written into the running config and then you would be able to see it. It is also stored in the vlan.dat with VTP transparent as well.


Citation - This blog post does not reflect original content from the author. Rather it summarizes content that are relevant to the topic from different sources in the web. The sources might include any online discussion boards, forums, websites and others.

No comments :

Post a Comment

 
/* Google Analytics begin ----------------------------------------------- */ /* Google Analytics end ----------------------------------------------- */